Why We Swapped Ovens for IR Lamps in Bio-sensor Fabrication When you’re building bio-sensors, the curing and baking stages are where things...

Getting Your Heat Right in a Smart Fab If you’re building out an Industry 4.0 smart Fab, you’ve probably realized that heat is a bit of a...

Keeping Things Safe When Your Cleaning Chemicals Get Volatile Let’s be honest: running infrared heaters in a chemical cleaning zone is a bit like...

Why we use Infrared Curing for Biosensors When you’re building biosensors, heat is a tricky thing. You need it to cure your adhesives and...

Stop Wasting Your Watts in the Fab Let’s be honest: wasting power in a wafer fab is basically a design flaw. When you’re running...

Stop Worrying About Your IR Heaters in Chemical Zones If you’re making bio-sensors, you know the drill. You need precise IR heat during the...

Why We Gold-Coat Our IR Lamps for Chemical Cleaning When you’re working in semiconductor fab, you’re often dealing with solvents that...

Stop Your IR Lamps from Ruining Your Wafers In a high-load semiconductor setup, a blown IR lamp isn’t just a “down-time” headache....

Stop Lamp Bursts from Killing Your Yield In a semiconductor fab, a lamp bursting is more than just a nuisance. It’s a nightmare. When a quartz...

Cleaning Up the Heat: Why Ozone-Free IR Just Makes Sense Getting your thermal ramping exactly right in semiconductor fab is a pain. Usually,...

Getting the Most Out of Your Wafer Curing Lamps Let’s be honest: energy waste in a smart Fab is basically just throwing money away. When...

Stop Cooking Your Equipment: A Better Way to Handle Heat in Semi Tooling In semiconductor fab, there’s a constant struggle. You need to get...

Stop Wasting Time With Hot Air: Why IR is the Way to Go for Semiconductor Rinsing Let’s talk about time. In semiconductor processing, every...

How High-Purity Quartz Infrared Lamps Keep Cleanrooms Truly Clean We built these carbon fiber infrared lamps for the one place that has zero patience...

Watch a wafer come off the wet station. If the drying lamp is lagging, you’ll see moisture hang around, and then the photoresist starts lifting....

On the lithography floor, a 0.5°C drift during the photoresist bake is enough to push critical dimensions out of spec and scrap a whole lot. TEL...